Auto-meter 1297 User Manual download pdf (Page 2)

12 MONTH LIMITED WARRANTY

Auto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in material and workmanship for a period of twelve (12) months from date of the

original purchase. Products that fail within this 12 month warranty period will be repaired or replaced at Auto Meter’s option to the consumer, when it is determined by Auto Meter Products, Inc. that the product

failed due to defects in material or workmanship. This warranty is limited to the repair or replacement of parts in the Auto Meter instruments. In no event shall this warranty exceed the original purchase price of

the Auto Meter instruments nor shall Auto Meter Products, Inc. be responsible for special, incidental or consequential damages or costs incurred due to the failure of this product. Warranty claims to Auto Meter

must be transportation prepaid and accompanied with dated proof of purchase. This warranty applies only to the original purchaser of product and is non-transferable. All implied warranties shall be limited in

duration to the said 12 month warranty period. Breaking the instrument seal, improper use or installation, accident, water damage, abuse, unauthorized repairs or alterations voids this warranty. Auto Meter

Products, Inc. disclaims any liability for consequential damages due to breach of any written or implied warranty on all products manufactured by Auto Meter.

SERVICE

For service send your product to Auto Meter in a well packed shipping carton. Please include a note explaining what the problem is along with your phone number. Please specify when you

need this product back. If you are sending product back for warranty adjustment, you must include a copy (or original) of your sales receipt from the place of purchase.

FOR SERVICE SEND TO: AUTO METER PRODUCTS, INC. 413 W. Elm St., Sycamore, IL 60178 USA (866) 248-6357

Email us at [email protected]

2650-1165-00 Rev. C 11/28/11

CAUTION!

As a safety precaution, the +12 V terminal of this product should be fused

before connecting it to the 12V ignition switch. We recommend using a 3 Amp,

automotive fuse or equivalent to help protect this product.

12V BATTERY

COIL

- OR -

LIGHT WIRE

- DASH

LIGHTING

CIRCUIT OR

12 VOLT (+)

12V IGNITION

SWITCH

GROMMET

IN FIREWALL

EARLY

MODEL

IGNITION

TACH

TERMINAL

ELECTRONIC IGNITION

WIRING

Mounting

1. Mount the 3

⁄8” tachometer in a 3

⁄8” dia.

hole and a 5” tachometer in a 4-5/8” dia.

hole in the dashboard.

(Be careful not to cut the hole too large.)

2. Cut a

⁄8” dia. hole in the firewall for

the tachometer wires. Place a rubber

grommet in the hole and route the

connector wires through the grommet to

the engine compartment.

3. Connect the tachometer wires as shown

in the Wiring Section.

4. Secure the tachometer to the dashboard

using the provided bracket & hardware.

Fuse

WARNING

Warranty will be void if connected to

coil when using an aftermarket ignition

box such as, but not limited to products

from the following manufacturers: MSD,

Crane, Jacobs, Mallory, Holley, Etc.. Prior

to installation of your tachometer, check

with the ignition box manufacturer for

recommended tachometer signal location.

" Models

⁄ 4"

⁄ 32"

⁄8

" Models

SEE WARNING BELOW

⁄ 8"

⁄ 32"

⁄ 8"

1 2

Comments to this Manuals

No comments

Auto-meter 1297 User Manual Page 2

Comments to this Manuals

Related products and manuals for For the car Auto-meter 1297