Auto-meter 1210 User Manual download pdf

Do not touch ignition wire to the sender terminal on

back of gauge or the sender will be damaged.

CAUTION:

INSTALLATION INSTRUCTIONS

⁄8" & 5" ELECTRIC QUAD GAUGES

2650-1178-00 Rev. A

Mounting

Mount a 3

⁄8" gauge in a 3

⁄8" dia. hole and a 5" gauge in

⁄8" dia. hole in the dashboard. Fasten with brackets supplied

as shown. (Electrical wire for installation not included.)

To assure proper functioning of this instrument, please read

instructions thoroughly before installing.

1. Gauge connects to 240-33 ohm fuel sender (3262), supplied in Quad

gauge/Speedometer kit. Sender is not included in individual Quad

gauges. The 3262 or comparable 240-33 ohm sender will be required.

Route proper length of 18 gauge wire from fuel tank to gauge. Connect

one end to terminal post on fuel level sender and the opposite end to the

spade terminal labeled “FUEL” on back of gauge. See illustration.

Voltmeter

1. Using 18 gauge wire, route wire through firewall using

grommet. Attach one end to the negative GND (-)

spade terminal on back of gauge, and the opposite

end to a good engine ground. See illustration at right.

2. Attach one length of wire to the positive +12V spade

terminal on back of gauge and opposite end to +12V

terminal on ignition switch or other switched +12V

power source.

To 12V Terminal on Ignition

Switch or other 12V source.

Step 1

1. Disconnect negative (-) battery cable.

Step 2

Fuel Level

Step 3

Do not touch ignition wire to the sender terminal on

back of gauge or the sender will be damaged.

CAUTION:

Grommet

5" Models

⁄16"

⁄8"

⁄32"

Ground

Grommet

CAUTION!

As a safety precaution the Red wire of this product

should be fused before connecting it to the positive

(+) side of the 12V DC battery. We recommend

using a 4 Amp, 3AG fast-acting type cartridge fuse

(Littlefuse

# 312 004 or an equivalent) inline with

the Red wire of our product.

⁄8" Models

⁄32"

⁄4"

PASSED

MODEL NUMBER

DATE OF MANUFACTURE

OIL

FUEL

WATER

+12V

GND

LAMP

5" Models

⁄8" Models

NOTE: Some late model vehicles use electronic sensors in their

pressure and temperature senders for engine control func-

tions. Before removing the original sender, we recommend

that you contact your automotive dealer to be sure no

critical functions will be disrupted. With pressure gauges

it is beneficial to add a T-fitting to install your new gauge

and to keep the warning light operational. This allows you

to monitor the pressure and still have a warning light to

indicate emergency conditions. The ground, fuel sender,

temperature sender, and oil sender wires should be routed

through fire wall using the supplied grommet.

QUESTIONS:

If after completely reading these instructions you have questions regarding the operation or installation of your instrument(s),

please contact Auto Meter Technical Service at 815-899-0801. You may also email us at [email protected].

Additional information can also be found at http://www.autometer.com

NOTE: Hook up of the voltmeter powers the quad gauge. Not

hooking up these wires will result in the other gauges not

working.

NOTE: The Quad gauge will not operate with any other resistance

range and cannot be modified to do so

Install grounded

wire to sender

flange screw for

proper operation

Ground

1 2

Summary of Contents

Page 1 - CAUTION!

Do not touch ignition wire to the sender terminal on back of gauge or the sender will be damaged.CAUTION:INSTALLATION INSTRUCTIONS3 3⁄8" & 5&

Page 2 - " models only)

FOR SERVICE CONTACT: AUTO METER PRODUCTS Inc. 413 W. Elm St., Sycamore, IL 60178 USA (815)899-0801 orEmail us at [email protected] MONTH LIMITED

Related models: 1213 | 2010 | 2011 | 2012 | 1211 | 1212 | 1225 |

Comments to this Manuals

No comments

Auto-meter 1210 User Manual

Browse online or download User Manual for For the car Auto-meter 1210. Auto Meter 1210 User Manual

Summary of Contents

Related models: 1213 | 2010 | 2011 | 2012 | 1211 | 1212 | 1225 |

Comments to this Manuals

Related products and manuals for For the car Auto-meter 1210